Delta flowmeter manufacturer

『Delta flowmeter manufacturer』Related information(v cone flow meter|rotary gas meter|gallon meter|gear meter|metal tube rotameter|glass tube rotameter|nutating disk meter|transit time ultrasonic flow meter|wedge flow meter|pd meters|hydraulic flow meter|ultrasonic water flow meter|water flow meter|air flow meter|magnetic water flow meter|oxygen flow meter|gas flow meter|argon flow meter|air velocity meter|gasoline flow meter|fuel flow meter|ultrasonic water meter|digital water meter|nitrogen flow meter|solid flow meter|Oxygen tank flow meter|digital water flow meter|diesel fuel flow meter|steam flow meter|02 flow meter|compressed air flow meter|oil flow meter|liquid flow meter)

1. Installation requirements for German Sister Delta flowmeter: The installation requirements for Delta flowmeter are as follows: Installation position and direction: Location selection: Delta flowmeter should be installed on a horizontal pipeline with sufficient straight pipe section, away from sources of heat, radiation, electromagnetic fields and other places that may cause interference. Direction requirement: Ensure that the inlet and outlet directions of the flowmeter are correct and cannot be installed upside down, otherwise it will cause serious errors in the measurement results due to dust entrapment. For vertical pipelines, the detection rod can be installed at any position along the circumference of the pipeline at 360 ° in the horizontal plane, but the high and low pressure impulse pipe joints should be on the same horizontal plane. Installation of impulse piping and condensing tank: The installation of impulse piping should ensure that the position of the high and low pressure impulse piping joints is correct, and the connection with the detection rod is tight without leakage. Condensation tank: In steam medium measurement, it is necessary to use a condensation tank to convert steam into condensed water, in order to avoid direct contact of steam with differential pressure transmitters causing high temperature and damage. Two condensers must be installed at the same height, and when the differential pressure transmitter is directly installed with the condenser tank, attention should be paid to installing the inlet at the same height. Installation of detection rod and probe: Insertion of detection rod: The insertion position of the detection rod should meet the design requirements, and the allowable deviation of the insertion angle should be within the specified range. Probe pressure measurement: The pressure measurement method of the Delta flowmeter is through a probe (probe) with a diameter of about 20mm, which has two rows of unevenly distributed 8mm pressure holes in front and behind the probe. Ensure that the probe is installed correctly and the pressure hole is unobstructed. Pipeline requirements: Straight pipe section: The straight pipe section before and after the throttling element must be straight and there must be no visible bending. The straight pipe section used for installing throttling components should be smooth. If it is not smooth, the flow coefficient should be multiplied by the roughness correction factor. Cleanliness: Before installation, it is necessary to ensure that the pipeline is clean, and there should be no foreign objects or impurities entering during the installation process to avoid affecting the measurement effect of the flowmeter. Other precautions: Installation of measuring tools: Use appropriate installation tools and methods to install and avoid damage to the flow meter. Verification and debugging: After installation, verification and debugging work should be carried out to ensure that the performance indicators of the flowmeter meet the design requirements. In summary, the installation requirements for the Deltaba flowmeter are strict and meticulous, and it is necessary to install and debug it correctly according to relevant regulations and instructions to ensure the accuracy and reliability of its measurement results.

2. What is a delta flowmeter?

The delta flowmeter produced by Jiangsu Technical Control Instrument Co., Ltd. for Boshu is a device that measures flow rate

『SILVER Official Website SERVICE』